Block Paving Sealer Product Support
WHAT ADVICE DO YOU
NEED THE MOST?
Application Advice
Coverage Advice
Suitable Surfaces
Technical Datasheets
Safety Datasheets
More Information
Performance Advantages
- Repels Water, Dirt & Oils
- Protects & Enhances Surfaces
- Long Lasting
- Wet Look Sheen
Available Sizes
Available Colours
Application Details
Preparation
- Surfaces should be clean, dry and free from oil, grease, dust, laitence and any other deleterious materials.
- Ensure the paving surfaces to be treated are clean and free from any mould or fungal growth.
- If oil stains are present, remove with detergent and hot water.
- Ensure cement composite pavers are thoroughly degreased and free from release agents which will affect penetration.
- If mould and fungal growth are present, clean surfaces with Britannia Fungical Wash as directed.
- All artificial stone (cement based) and all block pavers must be left for three months minimum after placing before over coating with this product. This will allow salts to leach out which otherwise may cause unsightly white patches appearing beneath the sealer, especially when the patio is wet.
Application
- STIR WELL BEFORE USE.
- Use as supplied without thinning down.
- Do not apply in temperatures below 5°C or above 25°C and should not be subjected to extremes of temperature until completely dry.
- The surface should be sectioned off to assist accurate coverage. Apply THIN uniform coats maintaining a wet edge but do not allow to puddle.
- It is important to undertake a representative test area to ensure that the product is suitable for your requirements prior to commencement of the project and assessed for appearance, chemical resistance and wet & dry slip resistance. This is particularly important where the surface has previously been sealed.
- Application should ideally be by an airless sprayer designed for solvent based products but application by brush or roller is also suitable. During application care should be taken to protect adjacent areas and equipment from overspray.
- Under normal conditions it will be touch dry within 1 - 2 hours and may be lightly trafficked in 24 hours.
For detailed application advice refer to the Product Datasheet
Coverage Details
- Up to 7m² per litres